Zanussi ZGG62413WS Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZGG62413WS. Zanussi ZGG62413WS 33 páginas.

•

Always use a correctly installed shockproof

socket.

•

Make sure that there is an access to the mains

plug after the installation.

•

Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

•

There is a risk of fire when the appliance is in

connection with an extension cable, an adapter

or a multiple connection. Make sure that the

ground connection agrees with the standards

and regulations.

•

Do not let the power cable to heat up to a

temperature higher than 90° C.

To prevent contact between the cable and the

appliance below the hob use the clamps which are

on the side of the cabinet.

CONNECTION CABLE

To replace the connection cable use only the

special cable or its equivalent. The cable type is:

H03V2V2-F T90.

Make sure that the cable section is applicable to

the voltage and the working temperature. The

yellow / green earth wire must be approximately 2

cm longer than the brown (or black) phase wire.

ASSEMBLY

min. 100 mm

min. 55 mm

30 mm

If a furniture unit is installed at a

distance of 400 mm above the

hob, there must be a minimum

safety distance of 50 mm to the

left or right from the edge of the

hob.

min. 650 mm

550 mm

400 mm

50 mm