Zanussi ZGO62414 Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZGO62414. Zanussi ZGO62414 16 páginas.
Também para Zanussi ZGO62414: Manual do utilizador (16 páginas), Manual do utilizador (16 páginas)

Imprimir página
A
B
A. End of shaft with nut
B. Washer
C. Elbow (if needed)
D. Rubber pipe holder for liquid gas
Liquid gas
Use the rubber pipe holder for liquid gas.
Always engage the gasket. Then continue with
the gas connection.
The flexible pipe is prepared for apply when:
• it can not get hot more than room
temperature, higher than 30°C;
• it is no longer than 1500 mm;
• it shows no throttles;
• it is not subject to traction or torsion;
• it does not get in touch with cutting edges or
corners;
• it can be easily examined in order to make
sure its condition.
The control of preservation of the flexible pipe
consists in checking that:
• it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
• the material is not hardened, but shows its
correct elasticity;
• the fastening clamps are not rusted;
• expired term is not due.
If one or more defects are visible, do not repair
the pipe, but replace it.
www.zanussi.com
C
WARNING!
When installation is complete, make
sure that the seal of each pipe fitting
is correct. Use a soapy solution, not
a flame!
Adjustment of minimum level
To adjust the minimum level of the burners:
1. Light the burner.
B
2. Turn the knob on the minimum position.
3. Remove the knob.
4. With a thin screwdriver, adjust the bypass
D
screw position (A).
A
WARNING!
Make sure the flame does not go out
when you quickly turn the knob from
the maximum position to the
minimum position.
Electrical connection
• Make sure that the rated voltage and type of
power on the rating plate agree with the
voltage and the power of the local power
supply.
• This appliance is supplied with a mains
cable and a plug.
• Always use a correctly installed shockproof
socket.
• Make sure that there is an access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• There is a risk of fire when the appliance is in
connection with an extension cable, an
adapter or a multiple connection. Make sure
that the ground connection agrees with the
standards and regulations.
• Do not let the power cable to heat up to a
temperature higher than 90° C.
11