Zanussi ZGX65424XA Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZGX65424XA. Zanussi ZGX65424XA 20 páginas. Hob

Imprimir página

(see table in "Technical Information" chap-

ter).

4. Assemble the parts, follow the same proce-

dure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or dif-

ferent from the necessary pressure, you must fit

an applicable pressure adjuster on the gas sup-

ply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the by-pass

screw position.

A) The by-pass screw

• If you change from natural gas G20 20 mbar

to liquid gas, fully tighten the by-pass screw

in.

• If you change from liquid gas to natural gas

G20 20 mbar, undo the by-pass screw ap-

proximately 1/4 of a turn (1/2 of a turn for Tri-

ple Crown burner).

Warning! Make sure the flame does not

go out when you quickly turn the knob from

the maximum position to the minimum position.

Electrical connection

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

• The appliance must not be connected with an

extension cable, an adapter or a multiple

socket. There is a risk of fire.

www.zanussi.com

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed

to the side of the cabinet, in order to avoid

any contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Electrical Requirements

Permanent electrical installation must agree with

the latest I.E.E. Regulations and local Electricity

Board regulations. For your own safety the in-

stallation must be done by a qualified electrician

(e.g. your local Electricity Board, or a contractor

who is on the roll of the National Inspection

Council for Electrical Installation Contracting

[NICEIC]).

The manufacturer refuses to be held

responsible, if these safety measures

are not abided by.

Supply connections:

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an effi-

cient earth connection in compliance with

the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the ap-

pliance installed.

The appliance is supplied with a 3 core flexible

powercable with a 3 amp plug. If it is necessary

to change the fuse, use a 3 amp ASTA-ap-

proved (BS 1362) fuse.

or E — Earth terminal