Zanussi ZXE66X Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZXE66X. Zanussi ZXE66X 12 páginas. Ceramic glass induction hob

Imprimir página

To remove the dirt:

1. – Remove immediately: melted plastic, plastic foil,

and food with sugar. If not, the dirt can cause

damage to the appliance. Use a special scraper

for the glass . Put the scraper on the glass sur-

face at an acute angle and move the blade on the

surface .

What to do if...

Problem

You cannot start the appliance or op-

erate it.

A sound operates when the appli-

ance is off.

A sound operates 6 times, the appli-

ance stops.

The residual heat indicator does not

come on.

The automatic warm up function

does not start.

A sound operates and appliance

starts and stops again. After 5 sec-

onds one more sound operates.

Sensor fields become hot.

The display changes between two

heat settings.

comes on.

2. Clean the appliance with a moist cloth and some de-

3. At the end rub the appliance dry with a clean cloth.

• The key lock or child safety device operates

the section "Locking/unlocking the control panel" and "Child safety de-

vice".

• You touched 2 or more sensor fields at the same time. Only touch one

sensor field.

• There is water or fat stains on the control panel. Clean the control panel

• Start the appliance again and set the heat setting in 10 seconds.

You covered one or more sensor fields. Uncover the sensor fields.

The cooking zone is not hot because it operated only for a short time. If

the cooking zone must be hot, speak to the after sales service.

• There is still residual heat on the cooking zone

zone cool down

• The highest heat setting is set. The highest heat setting has the same

power as the automatic warm up function.

You covered

. Uncover the sensor field.

The cookware is too big or you put it too near the controls. Put large cook-

ware on the rear cooking zones if necessary.

Power Management decreases the power of this cooking zone. Use cook-

ing zones on the other side.

• The automatic switch-off operates. Stop the appliance and start it again.

Overheating protection for the cooking zone operates. Stop the cooking

zone and start it again.

• The cookware is incorrect. Use the correct cookware.

• There is no cookware on the cooking zone. Put cookware on the cook-

ing zone.

• The diameter of the bottom of the cookware is too small for the cooking

zone. Use the correct cookware.

– Remove after the appliance is sufficiently cool:

limescale rings , water rings, fat stains, shiny met-

allic discolorations. Use a special cleaning agent

for glass ceramic or stainless steel.

tergent.

Possible cause and remedy

. Stop the function. See

. Let the cooking