Zanussi ZFT 12 JB Livro de instruções - Página 6

Procurar online ou descarregar pdf Livro de instruções para Congelador Zanussi ZFT 12 JB. Zanussi ZFT 12 JB 13 páginas. Freezer zft 12 jb

Imprimir página

When placing the refrigerator keep minimal

distances recommended in figure.

A : placing it under a wall-cupboard

B : placing it freely

Switch and indicator unit

For the usage of the switching and indicator unit see

chapters "Putting it into use", "Controlling the

temperature" and "Freezing".

Components of the appliance are as follows:

A) Green indicator lamp

This lamp lights when the appliance is under

power, i.e. the mains plug is in the mains socket.

B) Red indicator lamp

It lights up depending on the temperature inside

the appliance.

It lights for a short time when starting the

appliance, placing fresh food into it and when the

temperature control knob has been turned in

direction to lower temperatures.

It lights permanently when the temperature inside

the appliance is too high (overloaded with warm

food, door stayed open or the door seal does not

close properly) or possibly the appliance was

broken down.

C) Yellow indicator lamp and freezer switch

In the switched-on state of the switch (pops up

and lights by pressing) the compressor operates

continuously thus providing for the coldest

interior temperature - achievable by the freezer -

needed for freezing.

D) Temperature control knob

This knob is provided for setting and changing

the temperature inside the appliance.

Putting it into use

Put the plug into the mains socket. Turn the

thermostatic control knob according to the figure.

This time the red lamp starts giving light, the

compressor starts and cooling begins shortly.

When the red light goes out the temperature is

sufficient and the appliance is suitable for storing

frozen and deep-frozen foods.

Controlling the temperature

The thermostatic controller interrupts the operation

of the appliance automatically for more or less time

depending on the setting then restarts it assuring the

required temperature.

Setting the thermostat knob can be done practically

with a coin. Turning the control knob clockwise

cooling becomes more and more intensive.

In the appliance -18 °C or lower temperature can be

reached if the thermostat knob is set according to the

figure.

The thermostat can be switched off („0" position),

which means breaking the circuit of the compressor

i.e. stopping cooling.

The temperature coming about in the freezer is

effected by not only the position of the thermostatic

control and the ambient temperature, but frequency

of door openings and the quantity of food put into it,

etc.

In maximum position of the thermostat - in

case of increased demand e.g. during

heatwaves

the

continually. This does not cause damages to the

appliance.

Freezing

Freezing different products should always be done in

the freezing compartment after proper preparation.

Switch on the freezer switch (pops up and lights by

pressing) 4 hours before freezing food of small

quantities and about 24 hours before freezing

products of larger quantities. This time the

compressor operates continuously to reach the

temperature necessary for freezing.

Place in the foods to be frozen and let the appliance

operate for about 24 hours as written above.

Then push the fast freezer switch again (the yellow

light will go out and the switch turns to its original

position).

compressor

may

operate