Zanussi ZFT 710FW Livro de instruções - Página 10
Procurar online ou descarregar pdf Livro de instruções para Congelador Zanussi ZFT 710FW. Zanussi ZFT 710FW 16 páginas. Freezer zft 710fw
Imprimir página
If the appliance is not working correctly, please carry out the following checks before contacting your local Zanussi Service
Force Centre.
Problem
No power to the appliance
The temperature in the appli-
ance is too high
The temperature in the appli-
ance is too low
Excessive frost and ice has
built up
The appliance is noisy.
Green indicator flashing.
If after the above checks your appliance still does not
operate correctly, contact your local Zanussi Service
Force Centre.
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls.
Power or operation failure:
In case of power failure during the storage of frozen foods, make sure not to open the freezer door. Once the power fail-
ure is over, the yellow indicator (3) of the quick freeze function will light up and then, 5 hours after restart, it will automati-
cally go out.
If a short power failure occurs (max. 13 hours) and the product is full, the stored foods will not deteriorate. Otherwise you
must use the stored food as soon as possible (if the temperature of the frozen foods rises, their storability will be shorter).
Check stability of product support (all four feet should stand on floor).
If you fail to remedy a problem, please contact the nearest Service Force Centre.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The product will
continue to operate with the use of a reserve system until the problem is eliminated by the local Service Force agent.
10
Something Not Working
Possible Cause
No power at the socket.
There is a power cut.
The fuse has blown.
Thermostat control is set at „0".
The appliance is located in an unsuitable
position.
The thermostat control is set too low.
The thermostat control is set too high.
The door has been left open.
Something is obstructing the door.
The door gasket is dirty.
The appliance is not level.
Temperature sensor problem.
Check there is power at the socket.
Check there is not a power cut by
checking the household lights.
Check the fuse has not blown.
Check the thermostat setting.
Check the ambient temperature is with-
in the appliances operating limits of 16
°C to 32 °C.
Check that the thermostat control knob
is turned to the correct setting relative
to ambient conditions.
Set the thermostat control knob to a
lower position.
Check the door has not been left open.
Check nothing is preventing the door
from closing.
Check the door gasket is intact and
clean.
Check if the appliance stands stable
(all four feet should be on the floor).
Call the service personnel.
In-guarantee customers should ensure that the
above checks have been made, as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.
Solution