Zanussi ZFT10210WA Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Congelador Zanussi ZFT10210WA. Zanussi ZFT10210WA 17 páginas.
Também para Zanussi ZFT10210WA: Manual do utilizador (16 páginas)

Imprimir página
Zanussi ZFT10210WA Manual do utilizador
Problem
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
FastFreeze, or after changing
the temperature.
Temperature cannot be set.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appli-
ance is too low/too high.
Possible cause
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The FastFreeze function is
switched on.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The FastFreeze function is
switched on.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
Solution
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FastFreeze function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Switch off FastFreeze manual-
ly, or wait until the function re-
sets automatically to set the
temperature. Refer to "Fast-
Freeze function"
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FastFreeze function".
9