Zanussi ZRB632FW Manual do utilizador - Página 8
Procurar online ou descarregar pdf Manual do utilizador para Congelador Zanussi ZRB632FW. Zanussi ZRB632FW 16 páginas. Fridge freezer
Também para Zanussi ZRB632FW: Manual do utilizador (12 páginas), Manual do utilizador (13 páginas)
Imprimir página
Problem
Water flows on the ground.
There is too much frost and ice.
The temperature in the appliance
is too low.
The temperature in the appliance
is too high.
The temperature in the refrigera-
tion is too high.
The temperature in the freezer is
too high.
The appliance does not operate.
The lamp does not work.
If your appliance is still not working properly after making
the above checks, contact the After Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same power and
specifically designed for domestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
8
Possible cause
The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
Products are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may be set
incorrectly.
The Temperature regulator may be set
incorrectly.
The Temperature regulator may be set
incorrectly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same
time.
There is no cold air circulation in the
appliance.
Products are too near to each other.
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Attach the melting water outlet to the
evaporative tray.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Store products so that there is cold air
circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket. Contact a qualified
electrician.
Close and open the door.
Refer to "Replacing the lamp".
7. Open the door. Make sure that the lamp comes on.
1
Closing the door
1. Clean the door gaskets.
Solution
2