Zanussi ZUAN28FW Manual do utilizador - Página 13
Procurar online ou descarregar pdf Manual do utilizador para Congelador Zanussi ZUAN28FW. Zanussi ZUAN28FW 49 páginas.
Também para Zanussi ZUAN28FW: Manual do utilizador (17 páginas), Manual do utilizador (17 páginas)
Imprimir página
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Power indicator light flashes.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Possible cause
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The "FastFreeze function" is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.
An error has occurred in meas-
uring the temperature.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
Solution
Refer to "Control Panel" chap-
ter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func-
tion" manually, or wait until the
function deactivates automati-
cally to set the temperature.
Refer to "FastFreeze function"
section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FastFreeze function"
section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and Tips" chap-
ter.
Contact a qualified electrician
or the nearest Authorized
Service Centre.
13