Zanussi ZHC4284 Manual do utilizador - Página 17

Procurar online ou descarregar pdf Manual do utilizador para Campânula de ventilação Zanussi ZHC4284. Zanussi ZHC4284 44 páginas. Zanussi chimney hood product brochure
Também para Zanussi ZHC4284: Características (5 páginas)

Imprimir página

Fixing the Frame

If you wish to adjust the height of the frame, proceed

as follows:

• Unfasten the eight metric screws joining the two

columns, located at the sides of the frame.

• Adjust the frame to the height required, then replace

all the screws removed as above.

• Fix the Fixing Part of the Upper Chimney 26 to the

hanging kit using the 2 screws 12w (M3 x 8).

• Lift up the frame, fit the frame slots onto the screws

up to the slot end positions.

• Tighten the two screws and fasten the other two

screws provided; before locking the screws completely,

it is possible to adjust the frame by turning it, making

sure that the screws do not come out of their housing

in the adjustment slot.

• It is now possible to place and tighten the 4 safety

screws, Proceed as follows:

• drill the ceiling with a 10 mm ø bit taking as refe-

rence the holes of the side parts of the

upper chimney fixing part.

• insert the 4 dowels (provided).

• insert the washers (provided) to the screws and

tighten the screws

• The Frame must be securely fastened so as to support

both the weight of the Hood and the stress caused by

occasional axial pressure against the fitted Appliance.

After fixing, make sure that the base is stable even

when the Frame is subjected to lateral stress.

• If the Ceiling is not strong enough in the area where

the hood is to be fixed, the Installer must strengthen the

area using suitable plates and counterplates anchored

to resistant structures.

• Lift the frame up, making sure that the index over the

frame plate is turned backwards.

• Fit the frame slots onto the two screws inserted in the

ceiling as above, and turn until reaching the centre of

the adjustment slot.

• Tighten the two screws and fasten the other two screws

provided; before locking the screws completely, it is

possible to adjust the frame by turning it, making sure

that the screws do not come out of their housing in

the adjustment slot.

• The Frame must be securely fastened so as to support

both the weight of the Hood and the stress caused by

occasional axial pressure against the fitted Appliance.

After fixing, make sure that the base is stable even

when the Frame is subjected to lateral stress.

• If the Ceiling is not strong enough in the area where

the hood is to be fixed, the Installer must strengthen

the area using suitable plates and counterplates an-

chored to resistant structures.

INSTALLING THE COOKER HOOD

�

��

�