Zanussi ZHG51251G Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Campânula de ventilação Zanussi ZHG51251G. Zanussi ZHG51251G 13 páginas.

Imprimir página

Charcoal filter

CLEANING THE GREASE FILTER

Filters are mounted with the use of clips and pins

on the opposite side.

To clean the filter:

1. Press the handle of the mounting clip on the

filter panel underneath the hood (1).

2. Slightly tilt the front of the filter downwards (2),

then pull.

Repeat the first two steps for all filters.

3. Clean the filters using a sponge with non

abrasive detergents or in a dishwasher.

The dishwasher must be set to a low

temperature and a short cycle. The

grease filter may discolour, it has no

influence on the performance of the

appliance.

4. To mount the filters back follow the first two

steps in reverse order.

Repeat the steps for all filters if applicable.

REPLACING THE CHARCOAL FILTER

WARNING! The charcoal filter is

NON-washable! The filter cannot be

regenerated!

To replace the charcoal filter:

1. Remove the grease filters from the appliance.

Refer to "Cleaning the grease filter" in this chapter.

2. Turn the filter counterclockwise (1) and then

pull (2).

The time of saturation of the charcoal filter varies depending on the type of cook-

ing and the regularity of cleaning the grease filter. The activated charcoal filter is

not washable, cannot be regenerated and must be replaced approximately every

4/6 months of operation, or more frequently for particularly heavy usage.

To mount the filters back follow the steps in reverse

order.

In any case, it is necessary to replace the filters at

least every four months.

REPLACING THE LAMP

WARNING! Risk of burns and electric

shock! Disconnect the appliance from

the electricity before the operation!

Make sure that the light bulb has

cooled down before touching it.

WARNING! Risk of injury! Use

protective gloves to replace the lamp.

Risk of damage to the appliance! Do

not use sharp edged tools!

Replace the burnt light bulb in accordance with the

specifications:

Power (W)

Socket

Voltage (V)

Dimensions (mm)

ILCOS D Code (ac-

cording IEC 61231)

To replace the lamp:

1. The lamp cover has two slots on each side.

Use a flat non sharp plastic tool. Gently remove

the lamp cover from the appliance.

2. Replace the lamp.

3. Mount the lamp cover.

E14

220 - 240

37 x 100 (diameter x

length)

DRBB/

F-4-220-240-

E14-37/100