Zanussi ZCE 650 Folheto de instruções - Página 31

Procurar online ou descarregar pdf Folheto de instruções para Fogões Zanussi ZCE 650. Zanussi ZCE 650 32 páginas. Zanussi instructrion manual electric cooktop zce 650, zce 651

Imprimir página

Electrical connections

Any electrical work required to install this hob

should be carried out by a qualified electrician or

competent person, in accordance with the current

regulations.

THIS COOKER MUST BE EARTHED.

The manufacturer declines any liability should

these safety measures not be observed.

This cooker is designed to be connected to a

230 V 50 Hz AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this book.

The cooker is supplied without supply cord. A 3 core

flexible supply cord must be fitted, in accordance with

the specification given in the relevant tables.

1) Loosen the two fixing screws securing the back

protective screen of the cooker, then lift it up

and remove it. This will expose the terminal

block on the right bottom corner.

2) Loosen the two cable clamp screws and lift

the top section of the clamp enough to allow

the cable to be passed through.

3) Connect the red (live) wire to the terminal which

is marked with the letter "L".

4) Connect the black (neutral) wire to the terminal

which is marked with the letter "N".

5) After fitting a green or yellow/green sleeve over

the bare copper wire (earth wire), connect the

exposed end to the terminal which is marked

with the earth symbol

"E"coloured green and yellow.

NOTE:

The earth wire should be about 2 cm. longer

than the live and neutral wires.

6) Secure the cable by means of the clamp

screws and refit the back protective screen.

Supply Cable Specifications

For Uk use only

For Europe use only

or with the letter

The cooker should be connected to a double pole switch

with a minimum gap of 3 mm. between the switch

contacts and of a type suitable for the required load in

compliance with the current electric regulations. The

switch should be sited within 2m of the hob and be easily

accessible upon completion of the installation.

The switch must not break the yellow and green earth

cable at any point.

Ensure that the hob supply cord does not come

into contact with surfaces with temperatures

higher than 50 deg. C.

Connection Min. size

via

Cable/flex type

• Cooker

6 mm

Control

Circuit

Min. size Cable/flex Cable / flex type Fuse

3x 2.5 mm

FO 2375

Cable / flex Fuse

H05 VV-F

30 A

H05 RR-F

30 A

H05V2V2-F