Zanussi ZCV69068XE Manual do utilizador - Página 23

Procurar online ou descarregar pdf Manual do utilizador para Fogões Zanussi ZCV69068XE. Zanussi ZCV69068XE 29 páginas.

Imprimir página

REPLACING THE LAMP

WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
Residual heat indicator does
not come on.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation settle
on the food and in the cavity of
the oven.
There is no good cooking per-
formance using the Plus Steam
function.
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300 °C
heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
The fuse is blown.
The zone is not hot because it
operated only for a short time.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The lamp is defective.
There was a power cut.
You left the dish in the oven for
too long.
You did not fill the cavity em-
bossment with water.
Remedy
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Refer to "Activating the Plus
Steam function".
23