Clarke INDY OIL FREE Instruções de operação e manutenção - Página 8
Procurar online ou descarregar pdf Instruções de operação e manutenção para Compressor de ar Clarke INDY OIL FREE. Clarke INDY OIL FREE 10 páginas.
Imprimir página
PAINT SPRAYING HINTS
NEVER attempt to spray unless you are wearing suitable, approved
respiratory and eye protection.
REMEMBER that some modern paints require specialist respiratory
protection...always consult the paint manufacturers instructions.
1. GENERAL PREPARATION
a. Ensure that the area in which you will be spraying is clean and dust free.
b. Connect spray gun to compressor via suitable flexible hose.
c. With no paint in spray gun, test system for air leaks.
d. Cover adjacent pieces of equipment to prevent overspray. Mask areas
of the article not to be sprayed.
e. Ensure surface to be painted is clean, dry and free from oil and dust.
Check paint manufacturer's instructions for any special surface
preparation required.
REMEMBER - TIME SPENT PREPARING SAVES TIME SPENT FINISHING
2. PAINT PREPARATION
a. Achieve the correct paint viscosity. This should be done according to
paint manufacturer's instructions, and will vary according to type of paint.
b. Having mixed the paint thoroughly in a separate container, pour into the
spray gun paint container through a fine filter.
DO NOT OVERFILL SPRAY GUN PAINT CONTAINER - three quarters full is maximum
c. It is usually best to experiment with a couple of practice spray coats on a
piece of material with the same type of surface as the article you wish to
spray, eg. metal for a car body panel, wood for a piece of furniture etc.
d. Some common problems:
PROBLEM
CAUSE
Paint does not atomise
Paint is too thick, air
(comes out in blobs)
pressure is too low.
Paint dries before hitting Paint is too thin. Air
surface, leaving it dry
pressure is too high
with a rough texture
Finish is pitted like
Air pressure too high Reduce air pressure,
Orange peel
or spray too close to increase distance between
work
gun and work.
WARNING
CORRECTION
Add thinners. Increase air press.
(not above 50 psi, unless
specified by paint manuf.
Add more paint.
Reduce air pressure
- 8 -
TECHNICAL DATA
Model
Indy Air - (Oil Free)
Maximum Air Pressure
115 PSI
Air Displacement
3.5 CFM
Motor
½ HP
Voltage
230 vac & 110 vac
Weight
9.6 kg (Packed)
Part Number
Air Indy 110 Vac
3230071
Part Number
Air Indy 230 vac
2320070
Dimensions (mm)
340 x 150 x 270
SHUTTING DOWN THE COMPRESSOR
SHUTTING DOWN THE COMPRESSOR
1.
Ensure that the on/off switch is in the off -'O' position.
NEVER USE THE MAINS SWITCH TO STOP THE MOTOR.
2.
Depress equipment trigger (spraygun) to release air from the hose and
compressor before disconnecting from the machine.
3.
Switch off and remove mains.
-13 -