Clarke PP15ND Instruções de funcionamento e manutenção - Página 9
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Compressor de ar Clarke PP15ND. Clarke PP15ND 17 páginas. Air compressor
Também para Clarke PP15ND: Manual de operação e manutenção (10 páginas), Instruções de funcionamento e manutenção (20 páginas)
Imprimir página
When starting subsequently, start the machine as follows:
1.
At the beginning of the day, open the drain cock and allow any condensate
to drain completely, then close the cock.
2.
To ease starting, ensure there is no pressure in the pump outlet manifold by
opening the Bleed Valve (See Fig.2).
3.
Connect the air hose to one of the outlets and the air tool and set the pressure
regulator to zero pressure (turned fully anticlockwise).
4.
Start the engine in accordance with the instructions contained in the engine
service manual, then close the bleed valve and allow pressure to build up.
5.
When the Air Governor/Load Genie has operated and the compressor has
gone 'off line', slide the outlet valve outwards fully then adjust the pressure
regulator so that the desired pressure is registered on the gauge.
6.
Check for air leaks at the tool and connectors...as above, before proceeding
STOPPING THE COMPRESSOR
At the end of the day, stop the compressor in accordance with the instructions in
the engine manual, then open the drain cock.
Close the air outlet by sliding both valves inwards.
Operate the air tool trigger or operating lever etc., to ensure there is no pressure in
the air line, then disconnect airline and tool.
DO NOT under any circumstances attempt to remove the air tool or disconnect
the air hose until you are satisfied that the pressure has been relieved.
Finally, close the drain cock.
Take care not to touch the engine or pump as they remain hot for some time after
use.
WARNING!
- 9 -