Clarke XEP15/50 Manual de Instruções de Operação e Manutenção - Página 5

Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Compressor de ar Clarke XEP15/50. Clarke XEP15/50 17 páginas. Electric motor driven
Também para Clarke XEP15/50: Manual de Instruções de Operação e Manutenção (17 páginas), Manual de Instruções de Operação e Manutenção (17 páginas)

INSTALLATION

Before installing your machine, check that its air output is sufficient for the

equipment to be used. The air output from the compressor must be more than

the volume of air required. We recommend the following:

1. Firm and level site, and the use of floor mountings for stationary

compressors - anti-vibration pads. (Do not bolt machines directly to the

floor).

WARNING: MOVE THE COMPRESSOR ON A PALLET OR USING SLINGS

BENEATH THE RECEIVER NEAR TO THE DOMED ENDS, EMPLOYING A FORK

LIFT TRUCK OR WHEELED GANTRY CRANE. BEWARE OF OFF CENTRE

LOADS. THE WEIGHT OF THE COMPRESSOR IS SHOWN ON THE DATA TABLE

ON PAGE 2.

2. Dust and damp free environment.

3. Adequate ventilation for:-

• Air intake to compressor pump (in order to draw in clean air).

• Cooling to compressor pump, and electric motor.

4. To allow sufficient access for servicing, a minimum clearance of 500mm

must be allowed around the machine.

5. The power cable from the main supply must be large enough to carry the

starting and running load of the electric motor. This is particularly relevant if

the compressor is some distance from the source of supply.

6. Electrical installations should be completed by a qualified electrician.

7. Electrical connection to the mains supply must be via a suitably fused (see

table on page 6) approved plug or isolator (allowing sufficient capacity for

motor starting). If using a circuit breaker, ensure it is motor rated and of

sufficient size to allow for motor starting.

8. Compressors should be connected to mains electricity supply via an earth

leakage protection device (RCD).

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]