California PRO 1005 Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Lixadeira California PRO 1005. California PRO 1005 7 páginas. Composite orbital sander
Imprimir páginaPROBLEMS
Tool runs at normal
speed but loses under
load
Tool runs slowly. Air
flows slightly from
exhaust
Tools will not run. Air
flows freely from
exhaust
Tool will not shut off
Motor will not run
Sanding paper cannot
stick to the pad
Note: Repairs should be carried out by a qualified person.
POSSIBLE CAUSES
Motor parts worn.
■.
Cam clutch worn or sticking
■
due to lack of lubricant.
Motor parts jammed with dirt
■
particles
Power regulator in closed
■
position
Air flow blocked by dirt.
■
One or more motor vanes
■
stuck due to material build up.
'O' rings throttle valve
■
dislodged from seat inlet
valve.
Trigger valve curved or
■
blocked by dirt
The inside of Motor blocked
■
by dirt
Sanding pad damaged or
■
dirty
REMEDIES
Lubricating clutch housing.
■
Check for excess clutch oil. Clutch cases
■
need only be half full. Overfilling
Can cause drag on high speed clutch parts,
i.e. a typical oiled/lubricated wrench requires
1⁄2 ounce of oil.
GREASE LUBRICATED: NOTE: Heat usually
indicates insufficient grease in chamber.
Severe operating conditions may require more
frequent lubrication.
Check air inlet filters for blockage.
■
air tool lubricating oil into air inlet as per
■ Pour
instructions.
Operate tool in short bursts quickly reversing
■
rotation back and forth where applicable.
above as needed. If this fails return to
■ Repeat
service centre.
Pour air tool lubricating tool into air inlet.
■
Operate tool in short bursts of forward and/or
■
reverse rotation where applicable.
Tap motor housing gently with plastic mallet.
■
supply. Free motor by rotating drive
■ Disconnect
shank manually where applicable
If tool remains jammed return to service
■
centre.
Replace 'O' ring
■
Lubricate the trigger valve with special
■
lubrication. Or send the service center.
Lubricate the motor and operate tool
■
Operate tool in short bursts of forward and/or
■
reverse rotation where applicable.
If tool remains jammed return to service
■
centre.
Replace the sanding pad
■