Aleko Victoria Series Manual de instalação - Página 15

Procurar online ou descarregar pdf Manual de instalação para Acessórios Aleko Victoria Series. Aleko Victoria Series 20 páginas. Sizes 6.5x5 8x6.5 10x8
Também para Aleko Victoria Series: Manual de instruções de instalação e funcionamento (12 páginas), Manual de montagem (14 páginas), Manual de instalação (17 páginas)

STEP 4: Mounting the Wall Brackets

1. Now that the bolts are securely in the wall, remove the nuts that are loosely

placed over the bolts.

2. Place a wall bracket onto one set of bolts. This should be an easy fit if the

bolt holes are properly aligned.

3. Once the wall bracket is resting on the bolts, place a washer over the bolt,

then secure it with a nut, as shown in the diagram below.

4. The brackets MUST sit firmly on the wall. If there is any movement, you

must tighten it more.

5. Repeat this step for each of the wall brackets. Once you do this, all wall

brackets will be securely in place.

STEP 5: Mounting the Awning

1. Now that the wall brackets are secure and in place, it is time to

install the awning onto the brackets.

2. At least two ladders or sturdy chairs are required to install the

awning.

3. Put the original expansion bolts on the wall brackets and

tighten them.

4. Finally, fasten all expansion bolts.

5. Using the hand crank or a motor (if applicable), fully open your

awning. The front bar should be level.

6. Congratulations! Your awning is installed. If you are happy

with the height of the front bar (awning pitch), sit back and

enjoy! If not, please read on.

OPTIONAL INSTALLATION

☻

ADJUSTING THE AWNING PITCH/ANGLE

Each awning comes with a pre-set pitch (angle) that is considered ideal. However, if you need to make an adjustment, it

can be done in just a few easy steps.

Note: Be sure that the front bar is adjusted to be completely

even. Any misalignment will result in improper retraction.

IMPORTANT: Raising the front bar will reduce the pitch

(angle) of the fabric, thus increasing the risk of rain

water pooling on the fabric. To prevent the awning from

collapsing due to rain water weight, you must retract

the awning when unattended. Failure to do so could

result in a broken awning or personal injury.

Washer

Tighten

Loosen

to adjust

Jack Bolt

CROSS SECTION

OF WALL