Clarke Contractor CON180 Instruções de funcionamento e manutenção - Página 8
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Lixadeira Clarke Contractor CON180. Clarke Contractor CON180 16 páginas.
Imprimir página
BEFORE USE
WARNING: MAKE SURE THAT THE TOOL IS SWITCHED OFF AND
UNPLUGGED FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING
THE HANDLE OR BACKING PAD.
FITTING THE HANDLE
The handle is recessed to fit onto the
machine is not adjustable, but can
be fitted for left or right handed use.
1. Slot the handle onto the body of
the machine, locating the lugs
into the recesses in the machine
body.
2. When the handle is in position,
secure in position with the two hex
screws supplied. Tighten using the
hex key supplied. DO NOT overtighten.
FITTING THE BACKING PAD
1. Screw the backing disc onto the
spindle.
2. Press and hold the spindle lock
button and tighten the pad hand
tight in a clockwise direction.
• Either the polishing bonnet or a
sanding disc can be fitted. See
below.
IMPORTANT: Never press the spindle
lock button while the motor is
running. Failure to observe this instruction can cause internal damage or
lead to personal injury.
ATTACHING BONNETS AND SANDING DISCS
Align the bonnet or sanding disc carefully with the appropriate backing pad,
pressing down to ensure a good grip.
Always ensure that the backing pad is clean as a build up of dust & debris can
result in damage to the hooks and loops.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8