Clarke CONTRACTOR CON300 Manual de Instruções de Operação e Manutenção - Página 5
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Lixadeira Clarke CONTRACTOR CON300. Clarke CONTRACTOR CON300 17 páginas. Electric sander
Imprimir página
15. ALWAYS use recommended accessories. The use of improper accessories
could be hazardous.
16. ALWAYS remove plug from electrical outlet when adjusting, changing parts,
or working on the machine.
17. NEVER operate machine while under the influence of drugs, alcohol or
medication.
18. NEVER leave machine running unattended. Turn power off. Do not leave
the machine until it comes to a complete stop.
19. NEVER force the machine. It will do a better and safer job at the rate for
which it was designed.
20.
NEVER use power tools in damp or wet locations or expose them to rain.
Keep your work area well illuminated. do not use in explosive atmosphere
(around paint fumes, flammable liquids etc.). Avoid dangerous
environment.
ADDITIONAL PRECAUTIONS FOR ORBITAL SANDERS
1.
Always wear ear protectors/defenders, as the noise level of this machine
can exceed 85dB (A).
2.
Do not use the machine if the electric cable, plug or the motor, is in poor
condition.
3.
Keep the mains cable well away from the sander, and ensure an
adequate electrical supply is close at hand so that the operation is not
restricted by the length of the cable.
4.
Switch the machine OFF immediately the task is completed.
5.
Never allow the ventilation slots in the machine to become blocked.
6.
Always use the appropriate sanding medium for the material being
worked. Both metal and wood sanding sheets of various grades are
available from all good hardware stores.
7.
Do not attempt any electrical repair yourself. Consult a qualified
electrician, or our Service Department on 020 8988 7400
Additionally, please keep these instructions in a safe place for future reference.
DUST EXTRACTION
The sander is provided with a dust extraction facility, Please note however, that
this does not preclude the user from wearing a face mask to prevent the
inhalation of dust particles.
It is an EEC requirement that a dust extraction facility be provided on power tools,
however, due to the nature of the tool, some of the dust produced will be forced
into the surrounding atmosphere, and will not be collected.
5