Clarke CP254 Manual de Instruções de Operação e Manutenção - Página 9
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Lixadeira Clarke CP254. Clarke CP254 13 páginas. Electric car polisher
Também para Clarke CP254: Instruções de funcionamento e manutenção (13 páginas)
Imprimir página
MAINTENANCE
Wash the bonnets after each use by hand and use mild soap with water. Hang
them up to dry.
Store them flat and allow them to regain shape.
The motor must be correctly ventilated during operation. For this reason avoid
blocking the air inlets. If the supply cable needs replacing, this has to be done
by the manufacturer or his agent in order to avoid a safety hazard.
CLEANING
1. Keep the surface of the unit free of grit, dirt, and grease. Use soapy water
or non-toxic solvents. Do not use toxic solvents or thinners.
2. Keep the air vents free of foreign matter at all times.
3. If the motor does not operate, it needs to be serviced or replaced by a
qualified technician, contact the Clarke international service department.
VIBRATION EMMISIONS
Employers are advised to refer to the HSE publication "Guide for Employers".
All hand held power tools vibrate to some extent, and this vibration is
transmitted to the operator via the handle, or hand used to steady the tool.
Vibration from about 2 to 1500 hertz is potentially damaging and is most
hazardous in the range from about 5 to 20 hertz.
Operators who are regularly exposed to vibration may suffer from Hand Arm
Vibration Syndrome (HAVS), which includes 'dead hand', 'dead finger', and
'white finger'. These are painful conditions and are widespread in industries
where vibrating tools are used.
The health risk depends upon the vibration level and the length of time of
exposure to it......in effect, a daily vibration dose.
Tools are tested using specialised equipment, to approximate the vibration
level generated under normal, acceptable operating conditions for the tool in
question. For example, a grinder used at 45° on mild steel plate, or a sander
on soft wood in a horizontal plane etc.
These tests produce a value 'a', expressed in metres per second per second,
which represents the average vibration level of all tests taken, in three axes
where necessary, and a second figure 'K', which represents the uncertainty
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9