Clarke EZ-8 Manual do operador - Página 4
Procurar online ou descarregar pdf Manual do operador para Lixadeira Clarke EZ-8. Clarke EZ-8 20 páginas. Drum sander
Também para Clarke EZ-8: Funcionamento e segurança (2 páginas)
Imprimir página
- 1. Table of Contents
- 2. Operator Safety Instructions
- 3. Introduction and Machine Specifications
- 4. How to Transport the Machine
- 5. Machine Set-Up
- 6. How to Operate the Machine
- 7. Sanding Cuts and Sandpaper
- 8. Sander Adjustment Procedures
- 9. Routine Maintenance
- 10. Troubleshooting
- 11. Section II Parts and Service Manual
- 12. Assembly Drawing #1 11/01
- 13. Assembly Parts List #1
- 14. Assembly Drawing #2 10/01
- 15. Assembly Parts List #2 7/03
- 16. Wiring Diagram 9/92
DANGER:
Electrocution or injury could occur if the power cord encounters the sanding drum. Keep the
cord clear of the sanding drum. Always lift the power cord over the machine.
DANGER:
Electrocution or severe injury could occur if machine is connected to an electrical system that
is not properly grounded. Do not remove or disable grounding pin.
DANGER:
Electrocution could occur if maintenance or repairs are performed on a machine that has not
been disconnected from the power source. Always unplug machine before servicing.
WARNING:
Sanding dust can be airborne and can be breathed in while operating a sander. Always wear
a dust mask while operating sanding equipment.
WARNING:
Injury to the eyes and/or body can occur if protective clothing and/or equipment is not worn
while sanding.
performing any sanding operation.
CAUTION:
Maintenance and repairs performed by unauthorized personnel could result in damage or
injury. Maintenance and repairs performed by unauthorized personnel will void your warranty.
Servicing of this unit must always be referred to an authorized Clarke American Sanders
distributor.
CAUTION:
Use of this machine to move other objects or to climb on could result in injury or damage. Do
not use this machine as a step or furniture. Do not ride on this machine.
CAUTION:
The machine is heavy. Use the proper lifting technique when transporting the machine. Get
help to lift the machine.
CAUTION:
Serious damage to the floor can occur if the machine is left running in one spot while the
sanding drum is in contact with the floor. To avoid damage to the floor, feather cut in at a normal
sanding rate. Do not dwell while lowering or raising the sanding drum. Always sand at a
constant rate.
Page 4
Always wear safety goggles, protective clothing, and a dust mask while
Clarke
®
American Sanders EZ - 8 Sander Operator's Manual