Clarke Super E Edger Manual do operador - Página 6

Procurar online ou descarregar pdf Manual do operador para Lixadeira Clarke Super E Edger. Clarke Super E Edger 16 páginas. American sanders

Imprimir página

1. Pad

SANDING CUTS AND SANDPAPER

Initial Cut

The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. A coarse

abrasive should be used.

If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this

should occur during an initial cut, the abrasive has dulled and must be replaced.

Final Cuts

The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60 - 80

grit) grain abrasive.

If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive

(80 - 100 grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close

the pores on a wood floor making admission of a stain difficult.

Grain

Use

12 grit

For removing gross imperfections and

16 grit

restore evenness to old flooring. To remove

20 grit

build-up of paints and varnishes.

24 grit

30 grit

For first sanding of new flooring (maple, oak).

36 grit

For removing minor imperfections and finishes

from old flooring.

40 grit

For initial cut on new flooring (oak, walnut).

For removing minor imperfections and finishes

from old flooring.

50 grit

For first sanding of new flooring (cedar, pine,

fir) For clean-up of 16 grit.

60 grit

For clean-up from initial cut 36 grit.

80 grit

For final sanding of certain hardwoods. For

clean-up of initial cuts (50 grit).

100 grit

For final sanding of certain hardwoods and

conifers where a smooth surface is desired.

120 grit

For final sanding of certain conifers.

150 grit

For final sanding of certain conifers where a

smooth surface is desired for surface

roughening between coats of finish.

Page 6

7" Diameter

Standard Grade

Professional Grade

Part #/Qty

945300/50

945594/200

945301/50

945595/200

945302/50

945596/200

945597/300

945598/300

945305/100

945599/300

945600/300

945307/100

945601/300

945308/100

945602/300

945309/100

945603/300

945310/100

945604/300

945605/500

945606/300

American Sanders Super E Operator's Manual

Clarke

5" Diameter

Professional Grade

Standard Grade

Part #/Qty

945314/50

945315/50

945701/250

945316/50

945702/250

945703/250

945704/500

94319/100

945705/500

945706/500

945707/500

94321/100

945708/500

945322/100

945323/100

945709/500

945710/500

945324/100