Clarke 5060205 Manual de Instruções de Operação e Manutenção - Página 3
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Bomba de água Clarke 5060205. Clarke 5060205 8 páginas. Pressure test pump
Imprimir página
OVERVIEW
This Pressure Testing Pump is primarily intended for the pressure testing of new
heating installations prior to the connection to the boiler and for fault-finding
of leaks and identifying air ingress problems on existing systems.
When correctly connected to a pipeline/radiator network or complete central
heating system, this hand operated unit is used to build up the required
hydraulic pressure. The reservoir incorporates a filter to prevent dirt entering
the system under test and the gauge is shielded to prevent damage.
It may not be suitable for testing domestic low pressure domestic heating
systems which typically operate between 1.0 to 2.5 bar.
It can also be used for quick and exact pressure testing of installations such as
compressed air and refrigeration systems and small bore pipelines. However, it
is unsuitable for testing gas systems since liquid must be used.
PARTS SUPPLIED
When unpacking, check for damage and /or shortages etc. Any found should
be reported to your CLARKE dealer where the pump was originally purchased.
This Pressure testing pump should include the following:
1 x Pressure testing pump assembly
1 x Locking pin & chain
2 x Sealing washers (O-rings)
1 x High pressure hose
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3