Clarke 7230670 Manual de Instruções de Operação e Manutenção - Página 7

Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Bomba de água Clarke 7230670. Clarke 7230670 17 páginas.

The delivery hose should be attached to the outlet adapter which is supplied.

A gate valve may be installed in-line on the delivery side of the pump which

can be set as required to regulate the flow of water. Do not place any such

restriction on the suction side of the pump unless it is an isolator valve in a

gravity fed system.

It is IMPORTANT to note also that this pump should not be operated with the

delivery valve completely closed.

To prevent unnecessary strain or possible distortion to the pump, ensure that

adequate support is provided to the hoses and/or pipes. Remember they will

be considerably heavier when filled with water.

Should sand, chemical or other contaminants come into contact with the

pump, flush through with cold clean water as soon as possible.

Protect the pump and pipework from freezing. The formation of ice may

cause serious damage.

Where the pump is to be a permanent fixture, the fittings to the pump MUST be

flexible, i.e. a short piece of hose should be inserted between rigid metal

pipework and the pump.

It is strongly recommended that in addition to the coarser foot filter, an inlet

filter should be fitted to prevent the possibility of any foreign body from

entering the pump. This is particularly important in the case of multi- stage

pump such as the CBM240E. A filter specifically designed for all pumps in the

range is available from your CLARKE dealer.

The filter bowl is transparent allowing a visual check as to the condition of the

filter cartridge. The filter cartridge is a washable net type with a rated filtration

of 60 microns, suitable for the efficient removal of suspended particles such as

sand. The filter is NOT designed to filter mud, sludge etc.

This pump is provided with a non-return valve connected to the inlet port.

Screw the non return valve into the inlet port, ensuring the arrow, stamped on

the valve points inwards towards the inlet port. Tighten the valve, BUT DO NOT

OVERTIGHTEN, then screw the filter on to the valve - again DO NOT

OVERTIGHTEN. The filter should hang vertically when completed.

This pump is set up as a BOOSTER Pump by incorporating the CLARKE EPC 1000

HYDROTRONIC UNIT - a computerised electronic device which automatically

switches the pump ON and OFF whenever a tap, or other restriction in the

outlet side of the pump, such as a spray lance etc., is turned ON or OFF.

Please ensure you are thoroughly familiar with the operation of this device by

reading the enclosed leaflet describing its' operation and maintenance,

before you operate the pump. It is important to note that in order for the

hydrotronic unit to operate correctly, the maximum head ABOVE THE outlet

OF THE HYDROTRONIC UNIT, is 14 metres.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]