Alemite 8702-A Manual de serviço - Página 8
Procurar online ou descarregar pdf Manual de serviço para Bomba de água Alemite 8702-A. Alemite 8702-A 12 páginas. High-pressure hydraulic pump
Imprimir página
SER 8702
21. Screw the Tube assembly [with Loctite 222] into the
Adapter.
• Follow the thread sealant manufacturer's
recommendations.
• Do not tighten at this time.
22. Install O-Ring (4) onto the Adapter.
23. Apply grease to Piston (17).
• This will aid the installation process.
Install the outer component assembly onto the
inner assembly with care. Damage to Seal (21) can
occur.
24. Install the outer component assembly onto the inner
assembly.
• Use a slight twisting motion to pass the Seal.
• At the same time thread the Adapter into the base of
the air motor.
IMPORTANT: Make sure the flange portion
of the Adapter seats flush against the base of
the motor. Should a gap exist, inspect the
components of the air motor packing group.
25. Install Stop Washer (25) into the Extension.
26. Install and seat Seal (26) [heel end first] into Valve
Body (27).
Revision (1-10)
CAUTION
27. Install the Valve Body assembly (Seal first) onto
Rod (29).
• Make sure the Valve Body assembly seats properly
in the Extension.
28. Install and seat Valve Seat (28) [large diameter first]
into Primer Body (36).
29. Install and seat Gasket (6) into the Primer Body.
30. Screw the Primer Body onto the Extension.
31. Place a large wrench or other suitable tool into the slot
of the Primer Body.
• Tighten all the components of the assembly securely.
• Crush all Gaskets.
32. Extend Rod (29) from the Primer Body.
33. Install Primer Disc (31) onto the Rod.
34. Gently screw Nut (32) onto the Rod.
• Use an appropriate size punch in the hole of the Rod
to prevent rotation. See Figure 2.
• Do not overtighten.
35. Install O-Ring (33) into Follower Tube (35).
36. Install the Follower Tube onto the Pump.
37. Tighten Setscrew (34) that secures the Follower Tube
to the Adapter.
8
High-Pressure Hydraulic Pump
Alemite LLC