Directed Electronics K10 Manual de instalação - Página 11
Procurar online ou descarregar pdf Manual de instalação para Alarme para automóvel Directed Electronics K10. Directed Electronics K10 16 páginas. Directed electronics, inc. installation guide
Imprimir página
8 DOUBLE PULSE UNLOCK OFF/ON: Some vehicles require two pulses on a single wire to unlock the
doors. When the double pulse unlock feature is turned on, the BLUE H2/C wire will supply two nega-
tive pulses instead of a single pulse. At the same time, the GREEN H2/A wire will supply two positive
pulses instead of a single pulse. This makes it possible to directly interface with double pulse vehicles
without any extra parts.
9 SECURITY FEATURES ON/OFF: In the ON setting the (-) ground-when-armed output will be active
and can be used to operate starter kill. The unit will also trigger a panic sequence if the ignition is
turned on before disarming the system. Turning the security features off will turn off both the starter kill
feature and the triggered sequence with ignition.
10 CODE-HOPPING ON/OFF: The system features Code-Hopping as an option. To use Code-Hopping
technology, this feature must be programmed on.
remote coding
The system comes with two remotes that have been taught to the receiver. The receiver can store up to
four different remote codes in memory. Use the following learn routine to add remotes to the system or
to change button assignments if desired.
If the system was previously programmed using the Pro Security Programmer, the learn routine may be
locked. If the horn generates one long honk when attempting to program the remote, the remote cod-
ing is locked and must be unlocked using the Pro Security Programmer before proceeding.
1.
Key. Turn the key to the ON position.
2.
Choose. Within 10 seconds, press and release the Override switch the number of
times corresponding to the desired channel listed below. Once you have selected the
channel, press the switch once more and HOLD it. The LED will flash and the horn will
honk ( if connected) to confirm the selected channel. Do not release the Override switch.
3.
Transmit. While holding the Override switch, press the button from the remote
that you wish to assign to the selected channel. The unit will chirp indicating success-
ful programming. It is not possible to teach a remote button to the system more than
once.
4.
Release. Once the code is learned, the Override switch can be released.
12