Clarke CHS2E Instruções de funcionamento e manutenção - Página 6
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Bomba de água Clarke CHS2E. Clarke CHS2E 8 páginas. Water pump
Imprimir página
PREPARING THE PUMP FOR OPERATION
A. GENERAL.
Always prepare the site beforehand.
Ensure there is an adequate, firm foundation on which the pump may be located,
and as near the water source as possible.
Ensure there is adequate drainage for the discharged water, and that there is no
danger of damage to property as a result of the pumping operation.
B. THE ENGINE.
WARNING:
Never run the engine in an enclosed space
- ensure there is adequate ventilation.
This pump is not supplied with engine oil or fuel. Fill the engine crankcase with oil
as specified in the engine manual.
Fill the fuel tank with petrol.
Consult the engine manual and carry out all checks, and prepare for use as
specified.
C. THE PUMP
1.
Place the pump on a firm, level foundation, putting it as near as possible to
the water source, and ensure it is anchored where necessary, to prevent it
from moving during operation.
2.
Connect the suction hose to the pump housing, and ensure the complete hose
is sound. There must be no damage of any kind. The connection at the pump
body, and all other connections, (should there be any), must be air tight.
Hoses or pipes should he supported independently and not carried by the pump.
IMPORTANT : An air leak in the suction line will prevent priming, and reduce
the capacity of the pump. The vast majority of problems which may occur,
are as a result of air leaks in the suction line.
Pay particular attention to the following:
a. Use sealant on all threaded connections.
b. Always ensure the quick release gasket is in place, and correctly fitted.
c. Always use a flexible hose at the pump body connection, of at least 1ft
(300mm).
d. Keep all pipes/hoses as short and straight as possible, and avoid sharp bends.
e. If a flexible hose must he laid across a roadway, protect it with planking.
(Instantaneous shut off pressure, applied when a vehicle runs across an
unprotected hose, will cause "hydraulic shock", which can damage the
pump and/or the hose).
6
PARTS DIAGRAM
PARTS LIST
For Engine part no. - Consult your CLARKE dealer
No. Description
Part No.
-
Engine
See Dealer
1
Casing
DS801001
2
End Cover
DS501004
3
Impeller
DS801009
4
Inner Casing
DS801001
5
Outlet Connector
DS801019
6
Valve Casing
DS801013
7
Mechanical Seal
DS501010
8
Sealing Ring
DS501002
9
Packing Inner Casing
DS801012
10 Gasket Outlet Conn.
DS801020
11 Check Valve
DS801015
12 Plug
DS501012
13 Packing Plug
DS501022
14 Bolt M8x48
N/A
Model - CH3D
No. Description
Part No.
15 Spring Washer
N/A
16 Plain Washer
N/A
17 Seal Packing
DS501006
18 Frame
DS801030N
19 Bolt M10x30 SW
DS501003
20 Bolt M8x25 SW
DS501014
21 Bolt M8x30 SW
DS801014
22 Bolt M8x40 SW
DS501023
23 Flange Nut M6
N/A
24 Packing Coupling
DS801017
25 Hose Connector
DS801018
26 Hose Coupling
DS801016
27 Hose Clip
DS801028
28 Strainer
DS801029
11