Clarke ISP10A Instruções de funcionamento e manutenção - Página 3
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Bomba de água Clarke ISP10A. Clarke ISP10A 9 páginas. Submersible water pump
Imprimir página
SAFETY PRECAUTIONS
1.
This pump is designed to pump WATER ONLY. Never use for pumping
flammable liquids or chemicals of any kind.
2.
NEVER allow the pump to run dry.
3.
An approved Residual Current Device (RCD) MUST be used when pumping
from ponds or swimming pools.
4.
Your submersible pump may ONLY be used for pumping water from a swimming
pool when there is no person or animal in the pool.
5.
ALWAYS disconnect the pump from the electrical supply
before placing into, or removing from water, and
before any cleaning or maintenance.
6.
When raising or lowering the pump, ALWAYS use
a rope or chain attached to the handle. NEVER
lift or carry the pump by the mains cable or the
float switch cable.
7.
DO NOT run the pump with the body exposed
for longer than 10 minutes.
8.
DO NOT install the pump on sand, silt, mud etc.,
or ground which is likely to shift.
9.
If pumping water which is liable to freeze, the
pump MUST be run continuously, otherwise the pump must
be removed from the water and stored in a frost free location.
10. If the pump is to be used where there may be silt or mud
(e.g., garden ponds), ALWAYS keep the pump clear of any sediment by
standing it on a platform or bricks or suspending from a rope or chain attached
to the handle.
11. DO NOT use for permanent installation in pumping clean or pure water,
(particularly drinking water), as there is the remote risk of contamination, should
there be a leak in the seal device.
12. If the mains cable becomes damaged, it MUST be replaced - NOT repaired.
(see Electrical Installation).
13. If used in a confined space - in a shaft or sump etc., ENSURE the float has
sufficient room to operate correctly (see Installation on page 7).
14. Connection to the mains supply MUST be made well clear of the water, or, if in close
proximity, it must be completely waterproofed and secured to prevent the possibility
of it coming into contact with water. If necessary consult a qualified technician.
Failure to comply with these safety precautions could be extremely
hazardous, not only causing a risk to personal safety but also damage to
the pump, which could invalidate your guarantee.
WARNING
4