Directed Electronics 550.6 Manual do Proprietário - Página 11
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Directed Electronics 550.6. Directed Electronics 550.6 16 páginas. Directed electronics, inc power amplifier owner's manual
Imprimir página
TOP PANEL FEATURES
Control Panel Cover
The amplifier's gain and filter controls
are mounted under the elliptical control
panel cover. Magnets hold the cover
snugly and allow easy access.
T T o o i i n n s s t t a a l l l l t t h h e e c c o o v v e e r r - Place the
straight end of the control panel
cover into the notched end of the
amplifier's
top
elevating the curved end. Lower the
curved end of the cover until the
magnets make contact.
T T o o r r e e m m o o v v e e t t h h e e c c o o v v e e r r - Place a finger
on the curved end of the cover
while lifting up the straight end
with your thumb. When the
magnets lose contact, lift and
remove the cover.
Illuminated Window
Alignment
The illuminated window comes attached
to the control panel cover with a light
adhesive tape. An additional supply of
precut adhesive tape is included in the
hardware pack.
1. Firmly hold the control panel cover
while gently pressing against the
window from the top. If the window
will not release easily use a small flat
tool to pry it loose. Pry slowly and
evenly from several points to avoid
deforming or cracking the window.
© 2002 Directed Electronics, Inc
2. Apply two of the precut pieces of
3. Turn the illuminated window so the
panel
while
Viper Badge Mounting
The Viper Badge can be rotated in 90-
degree increments to accommodate the
amplifier's final mounting position.
1. Determine the final mounting posi-
2. Determine the position required for
3. Remove the protective cover for the
4. Align the badge guideposts with the
5. Press down firmly until the logo is
adhesive tape to the corners of the
window that don't have tape. Make
sure to apply the tape to the side
that makes contact with the cover.
Save the other two precut pieces of
tape for future use.
Viper snake logo will be in an
upright position when the cover is
re-attached to the amplifier. Press
the window onto the underside of
the control panel cover using the
positioning pins for alignment.
tion of the amplifier.
the badge to be viewed horizontally.
adhesive tape on the under side of
the badge.
holes in the amplifier top panel.
securely attached to the amplifier.
11