Clarke 6470162 Manual de Instruções de Operação e Manutenção - Página 7
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Serra Clarke 6470162. Clarke 6470162 17 páginas. 355mm abrasive cut-off saw
Imprimir página
UNPACKING AND ASSEMBLY
Unpack the saw carefully and ensure that the following items are in the box. In
the event of any deficiencies you should contact your CLARKE dealer
immediately.
• Abrasive Cut-off Saw
• 355mm cutting disc (supplied fitted)
• Double ended ring and hex spanner
BEFORE USE
UNLOCKING / LOCKING
To unlock the saw and raise the motor
arm.
1. Push down on the handle (1).
2. Pull the locking pin out slightly (2) to
unlock the motor arm.
3. Release the pressure on the handle.
• The motor arm will then raise into
position.
• Reverse step 2 when locking the motor arm down for storage.
MATERIAL CLAMPING AND SUPPORT
• Angle iron should be clamped and cut with both legs resting against
the base of the saw.
• A spacer block slightly narrower than the workpiece can be used to
raise the workpiece if required.
• A long workpiece must be supported by a block so that it will be
level with the top of the base. The cut-off end should be free to fall
downward to avoid binding against the wheel.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7