Clarke contractor CON100 Instruções de funcionamento e manutenção - Página 9
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Serra Clarke contractor CON100. Clarke contractor CON100 17 páginas. Contractor reciprocating saw
Imprimir página
OPERATION
TIPS
Cutting wood
• Clamp the workpiece securely and remove all nails and metal objects.
• Holding the tool with both hands, work with the saw shoe pressed against
the workpiece.
Plunge cutting in wood
• Rest the saw shoe on the
workpiece in such a position that
the blade forms an appropriate
angle for the plunge cut.
• Switch on the tool and feed the
blade into the material at full
speed, make sure that the saw
shoe remains in contact with the
workpiece at all times.
Pocket cuts
• Measure and mark the required pocket cut.
• Using a narrow saw blade rest the bottom of the saw shoe on the
workpiece and make sure that the blade is positioned on the cutting line.
If necessary, e.g. in confined spaces, use the outer edge of the saw shoe
as your guideline.
• Switch on the tool and feed the blade into the material at full speed,
holding the tool firmly against the workpiece.
Cutting metal
• When cutting thin metal always stabilize the workpiece with wood on
both sides. This guarantees clean cuts and prevents damaging the
material.
• For long, straight cuts draw a line on the workpiece.
• Apply a thin film of lubricant along the cutting line, switch on the tool and
follow the cutting line.
Cutting plastics
• Always work at reduced speed. Carry out a test cut to check whether
the material is sensitive to heat.
9