Clarke MBS600D Manual de instruções de montagem - Página 5

Procurar online ou descarregar pdf Manual de instruções de montagem para Serra Clarke MBS600D. Clarke MBS600D 9 páginas. 600 mm compound mitre saw

6. With the saw frame assembly in

position, tension the blade using

the wing nut, until any sideways

deflection of the blade is minimal.

• This is essential to ensure a straight

and repeatable cut from the

blade.

• The saw blade can be removed

for replacement by loosening the

wing nut fully and disengaging

the blade from its mounting pegs

at each end of the frame.

WORK CLAMP

1. Pass the threaded shaft of the

work clamp into one of the holes

in the front face of the saw table,

(see fig 5), depending upon

which end of the table your work

is to be mounted.

2. Screw on the retaining nut to

keep it in place.

WORK- STOP

1. Screw the stop rod adjusting knob

into the threaded hole at one end of the saw table depending upon

which side of the saw blade your work is to be mounted.

2. Slide the work stop rod through the base until it emerges from the hole in

the opposite end. Set it in the position required, by tightening the thumb-

screw.

• Your saw is now fully assembled and ready for use.

You may wish to install the saw on a firm foundation such as a workbench or

work table. This is particularly advisable if you are cutting larger workpieces.

Use the holes in the wooden base plate for this purpose, securing with bolts,

flat washers and wing nuts for quick and easy removal, if required (not

supplied).

Parts & Service: 020 8988 7400/E-mail: [email protected] or [email protected]

FIG 4

FIG 5

RETAINING NUTS

TENSIONING WING NUT

WORK

CLAMP

WORK

STOP

ROD