Clarke TS125 Manual de Instruções de Operação e Manutenção - Página 11
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Serra Clarke TS125. Clarke TS125 20 páginas. Multi purpose 5”(125mm) twin blade saw
Imprimir páginaCUTTING CROSS SECTIONAL MATERIAL
The life span of the blade and the quality of the cutting edge is dependent
on vibrations being kept to a minimum. For this reason the material must
always be clamped in place before work proceeds.
Flat bar iron
The blade is fed at an angle of
90° to the work surface
U-section
The blade is fed from corner to
corner.
Pipes
The blade is fed through the
object until it reaches the lower
edge, angled as it goes so that
the blade hits the material at an
angle of 90°.
The Blade Cover Guard is fixed to protect the operator from chips. When the
blades rotates, the chip flow comes out in both directions, which must be
observed.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Corner piece
The blade is fed diagonally
through the work surface.
Aluminium/copper
The machine must always be
equipped with the lubricating
device, to be used when
cutting all kinds of aluminium
and copper.
Spiral tube and longitudinal
cutting
Feed the blade through the
material, so that the blade only
protrudes through approx. 10
mm, do not drive it as far as the
blade's entire cutting edge.
Then start to feed the blade
forwards or backwards.
11
Rectangular pipe
The blade is fed from corner to
corner.
Shaped plate
The plate must always rest on
three mounts, with one on either
side of the cut.
Thin plate
Only feed the blade down
approx. 10 mm. Then start
cutting.