Clarke CONTRACTOR DEVIL371PD Instruções de funcionamento e manutenção - Página 11
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Aquecedor Clarke CONTRACTOR DEVIL371PD. Clarke CONTRACTOR DEVIL371PD 17 páginas. Devil quartz halogen heater
Imprimir página
CLEANING & MAINTENANCE
If the heater has been used, always allow it to cool down for at least 15
minutes and disconnect from the power supply before performing any
maintenance tasks.
FITTING/ REPLACING HALOGEN TUBES
Before attempting to fit/replace halogen lamps, ensure the heater is switched
off and isolated from the electrical supply by removing the plug from the
socket.
NEVER handle the heater tubes with bare hands. ALWAYS handle using either a
soft clean glove or a piece of soft clean cloth wrapped around the lamp.
1. Loosen and remove the two pozidrive screws securing the wire guard,
remove the guard and store removed parts safely.
2. To remove the tube, grasp and gently but firmly push it to one end of the
heater. The tube holders are spring loaded and will allow the tube sufficient
movement to clear the opposite holder.
3. Remove the tube and dispose of it, according to local regulations.
4. Fit new halogen tubes in reverse order.
5. Replace the guard using the screws removed earlier.
The heater is now ready for use again.
PERIODICALLY
1. If there is any serious build up of dirt, wipe the exterior thoroughly with a
damp cloth. Take care that no moisture enters the heater. Take care NOT
to touch the tubes with your fingers.
2. Inspect the power cable for damage. Undue heat will cause the cable to
stiffen and crack. If this is found, have the cable replaced. Check cable
routing and ensure it is well away from the heat source.
3. Ensure heating tubes are clear of dust (use compressed air to clean if
possible. (ALWAYS wear a dust mask if performing this operation)
4. Refer to your CLARKE dealer if internal repair is required.
5. When storing the heater, allow it to cool down, then place it in its packing
box for storage in a dry, ventilated place.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11