Clarke 6500411 Manual de Instruções - Página 8

Procurar online ou descarregar pdf Manual de Instruções para Ferramentas Clarke 6500411. Clarke 6500411 13 páginas. 12” disc sander

ADJUSTING THE WORK TABLE

1. Adjust the work table to the

desired angle by slackening the

two table clamps, one either side,

2. Move the table to the required

angle.

3. Retighten the clamps.

• The clamps are spring loaded.

Turn the lever clockwise to

clamp, as far as possible.

• Then pull the lever out against

spring pressure which allows the

lever to be turned

anticlockwise without

unclamping.

• Allow the lever to spring inwards again, then proceed to turn it

clockwise once more.

NOTE: Repeat the process until the table is securely clamped.....but DO

NOT overtighten, otherwise damage to the mechanism will occur.

1. Press the GREEN START button

marked 'I'.

• Allow the disc to reach full

speed before commencing

work.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]