Clarke CONTRACTOR 6462120 Manual de Instruções de Operação e Manutenção - Página 8
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Ferramentas Clarke CONTRACTOR 6462120. Clarke CONTRACTOR 6462120 12 páginas. Stair jig
Imprimir página
NOSE
TREAD
Ø16mm Cutter
22.0mm
10mm Offset
25.4mm
Ø22mm Cutter
28.1mm
7mm Offset
32.0mm
12. Attach the aluminium
spacers, (steps 1 to 4
below) to the relevant
slots in the jig, push
spacers firmly against the
edge of the string. Ensure an
equal amout of the stud is
visible on both sides when the
spacers are tightened ('A' = 'B').
Tighten the spacers by turning them in
opposing directions until tight (hand tight only).
Fit washer and wingnut on the top two studs and
gently tighten.
Attach the sliding bar to the bottom studs and secure with washers and wingnuts.
The jig is now fully assembled, and does not require dissasembling for storage etc.
To use agin, simply loosen wingnuts and spacers, adjust the jig accordingly.
Aluminium
Spacer X 4
1
-7-
22.0mm
25.4mm
Bush 2
Ø16mm Cutter
8mm Offset
Bush 3
Bush 2
Ø22mm Cutter
5mm Offset
Bush 3
11. Line up The jig perfectly with the two offset lines,
Threaded Stud X 2
'A'
2
'B'
Sliding Bar
28.1mm
Ø16mm Cutter
10mm Offset
Bush 1
Ø22mm Cutter
7mm Offset
Bush 1
as per diagram Clamp the jig firmly to the string
in this position.
Wing Nut X 4
3
4
Washer X 4
32.0mm
Ø16mm Cutter
8mm Offset
Bush 4
Ø22mm Cutter
5mm Offset
Bush 4
Jig