Acorn AKF 40 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Monitor Acorn AKF 40. Acorn AKF 40 11 páginas.

Imprimir página
as noted below. The moulded plug which
was cut off must be disposed of as it would
be a potential shock hazard if it were to be
plugged in with the cut off end of the mains
cord exposed. As the colours of the wires
may not correspond with the coloured
markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured green and yellow
must be connected to the terminal in the
pl ug w h i c h i s m a r k e d b y o n e o f th e
following: the letter E, the safety earth
symbol, the colour green, or the colour
green and yellow.
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N, or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L, or coloured red.

Installation

Positioning/Venti|ation
WARNING: WHEN POSITIONING THIS
EQUIPMENT ENSURE THAT THE MAINS
PLUG AND SOCKET ARE EASILY
ACCESSIBLE.
Do not place the monitor near a source of
heat. To prevent overheating, ensure that
the ventilation openings of the monitor are
not covered.
2
Movab|e Support
The movable support at the bottom of the
monitor provides three different viewing
angles (5, 10, 15 degrees) of the monitor to
the user.
First put the monitor leftside down. Pull up
the support then click it to either hook for
preferred viewing angle.
For Tilt and Swivel fitting instructions see
fold out sheet at rear of guide.
Connection to the Mains
You can connect the monitor to a mains
voltage of between 220 and 240 V. If the
mains voltage in your home is different from
this, please consult your dealer.
Connect one end of the mains lead to the
mains socket at the back of the monitor, and
the other end to the mains supply.