Lenovo RackSwitch G8296 Manual de início rápido - Página 20
Procurar online ou descarregar pdf Manual de início rápido para Interruptor Lenovo RackSwitch G8296. Lenovo RackSwitch G8296 22 páginas. Onie for lenovo network operating system
Imprimir página
Uninstalling the Lenovo Network OS
20
Lenovo ONIE Quick Start Guide for G8296
If you wish to run another network operating system (NOS), you can uninstall the
Lenovo Network OS by using the ONIE Uninstall mode. For more details, see
"Booting in ONIE Uninstall Mode" on page
Notes:
If the switch does not have ONIE installed, you must first install a ONIE FoD
license key and then set up the software on the networking device. For more
details, see
"Installing the ONIE FoD License Key" on page 12
ONIE" on page
14.
If you are connected to the switch through the mini-USB serial console port,
once you have uninstalled the Lenovo Network OS you must configure the default
baud rate from 9,600 bps to 115,200 bps.
Once you have uninstalled the Lenovo Network OS from the network device, see
"Using ONIE without Lenovo Network OS" on page
After booting in ONIE Uninstall mode, the following should be displayed:
Loading Open Network Install Environment ...
Platform: -lenovo_g8296-r0
Version : lenovo-internal
...
discover: Uninstall mode detected.
Erasing u-boot environment NOR flash region
Erasing 128 Kibyte @ 20000 - 100% complete.
Erasing internal mass storage device: /dev/mmcblk0 (7631MB)
Percent complete: 100%
Erase complete.
Uninstall complete.
discover: Uninstall mode detected. No discover stopped.
Stopping: dropbear ssh daemon... done.
Stopping: telnetd... done.
Stopping: syslogd... done.
Info: Unmounting kernel filesystems
The system is going down NOW!
Sent SIGTERM to all processes
Sent SIGKILL to all processes
Requesting system reboot
Restarting system.
...
discover: installer mode detected.
Starting: discover... done.
Please press Enter to activate this console. Info: eth0:
link... up.
Info: Trying DHCPv4 on interface: eth0
Warning: Unable to configure interface using DHCPv4: eth0
ONIE: Using default IPv4 addr: eth0: 192.168.3.10/24
ONIE: Using link-local IPv4 addr: eth0: 169.254.166.99/16
ONIE: Starting ONIE Service Discovery
Once the NOS uninstall process is complete, the switch is reloaded and configured
to boot in ONIE Install mode.
17.
Running uninstaller.
Rebooting...
Running installer.
and
"Installing
21.
Checking