Nikon D60 Manual - Página 18

Procurar online ou descarregar pdf Manual para Lente de câmara Nikon D60. Nikon D60 22 páginas. How do i know if my shutter is failing of 2022 - go wiki
Também para Nikon D60: Manual de início rápido (2 páginas), Brochura e especificações (18 páginas), Brochura e especificações (8 páginas), Brochura e especificações (8 páginas), Manuais (27 páginas), Manual de início rápido (16 páginas), Como é que (6 páginas)

Camera Settings

Note: These steps are already done in manufacturing, but you may need to reset these setting if

the camera is used in an automatic mode for other photography.

A. Lens Settings – Nikkor 105mm VR Lens -- These steps are already done in manufacturing.

1. Put the lens in Manual Focus Mode

a. Set the top lens setting to M (to the right, toward the lens mount). The lens is fixed at

minimum focus and must always remain so fixed (closest focus is 0.314 m, 1:1).

b. Black plastic tape is in place to keep this minimum focus set.

2. The middle switch can be in either position (FULL or inf-0.5m) since AutoFocus is OFF.

a. Black plastic tape is in place to keep this switch set correctly.

b. This setting is not critical

3. Put the lens in Non-VR mode

a. The bottom switch for VR should be set off (to the right, toward the lens mount).

b. Black plastic tape is in place to keep this switch set correctly.

B. Camera Menu Settings – Nikon D60 -- These steps are already done in manufacturing.

4. Put the camera in Manual Flash Mode:

a. With camera switched on, press the Menu button

b. In the left column are four icons:

i. Playback Menu (a right-pointing arrowhead)

ii. Shooting Menu (camera icon)

iii. Custom Setting Menu (pencil icon)

iv. Set Up Menu (wrench icon)

v. Retouch Menu (paintbrush icon)

c. Select the Custom Setting Menu by pressing the left-arrow on the command disc, then

the up or down arrow to highlight the pencil icon (the top should say Custom Setting

Menu)

d. Move up or down the submenu with the up or down arrow on the command disc

e. Select 14 – Built-in Flash using the command disc

f. Enter the submenu by pressing the right-arrow on the command disc

g. Select M Manual Flash, then press the right arrow for OK

h. Select Full power, then press the right arrow for OK

5. Set the camera's White Balance to Flash:

a. Press left arrow to go to left vertical Navbar and select the second icon (camera) for

Shooting Menu

b. Press Right Arrow and then the Down arrow; go down to "White Bal"

c. Enter the submenu by pressing the right-arrow on the command disc

d. Press Down Arrow until "Flash" is highlighted, then Press Right Arrow twice for OK

6. Press the Menu button twice to exit all menus.

7. If you have further questions, please contact Jon Miles at [email protected]

Use of Iris Camera – MEC-2-CB-D60-N105