Nikon MD-4 Manual de instruções - Página 13

Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras Nikon MD-4. Nikon MD-4 23 páginas. Motor drive

CONTROLS IN DETAIL

frames in commercially-available cartridges. You

can also shoot short bursts by setting the counter

to the number you want (Fig. 1). When the counter

reaches "O," the motor drive stops and one LED

lights up (Fig. 2). To reset the frame counter for

another burst, first turn the counter setting

dial to the orange dot and the LED will go out

(Fig. 3). Then you can rotate the counter to the

desired number. Before resetting the counter, make

sure to check the camera's frame counter to de-

termine whether there are enough exposures left

on the roll for the next burst.

continued

Note: If you rewind the film before the frame counter reaches

"O," the counter will not reset properly to the orange dot.

Therefore, before starting to shoot your next roll of film,

make sure to reset the counter to the desired setting.

The film becomes brittle in low temparatures. In cold climate,

be careful not to overestimote the number of frames remaining

on a roll of film since thismayresultin the motor pulling the

Rlm offthe supplyspool or damaging its perforated edges. R may

be a good practice to set the frame counter to one less than the

number af frames remaining on a roll of film. For example, if

you food a fresh S6-exp. roll, set the frame caunter to 35.

Distributed by WWW.LENSINC.NET