Cub VS-95A043 Manual do utilizador e manual de instalação - Página 8
Procurar online ou descarregar pdf Manual do utilizador e manual de instalação para Eletrónica para automóveis Cub VS-95A043. Cub VS-95A043 16 páginas. Blind spot detection system for passenger cars
Imprimir página
3-3 Installation steps
Note: Please ensure that the heat insulation film on the rear windshield
does not contain metal components.
Please prepare a tape measure, a multimeter and an alcohol pad before
installing.
1
Find a position ±10 cm at the center of the rear windshield's upper edge
with a tape measure, and wipe it with an alcohol pad.
Note 1: There must not be any no-original object such as driving recorder,
brake light and other devices within 5 cm left and right of the radar.
Note 2:
If the third brake light is located at the center of the rear
windshield's upper edge, it is recommended to install the radar
beneath it with the distance at least 2 cm.
2
Tear off the tape on the radar's bracket, face the surface printed with
the logo Cub outwards, and attach the bracket parallel and close to the
ceiling or align along the defog line. Be careful not to attach it to the
defog line.
3
Flip down radar's level, adjust the bracket until the bubble in the level is
at the center of the two vertical black lines, and then tighten the knob.
Radar installation position diagram
10cm
Center of rear windshield
7
Radar
10cm