Armstrong 4039 Series Manual de instruções de instalação e funcionamento

Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Bomba de água Armstrong 4039 Series. Armstrong 4039 Series 8 páginas. Belt driven pumps

Imprimir página
CE CONFORMITIES
For declaration of Conformities contact Armstrong.
INTRODUCTION
This document contains specific information regarding the safe installation, operating and maintenance of the Series
4039 pumps and should be read and understood by installing, operating and maintenance personnel. The equipment
supplied has been designed and constructed to be safe and without risk to health and safety when properly installed,
operated and maintained. The instructions following must be strictly adhered to. If clarification is needed on any point
please contact Armstrong quoting the equipment serial number.
WARNING SYMBOLS
Safety instruction where an electrical hazard is involved.
Safety instruction where non-compliance would affect safety risk.
Safety instruction relating to safe operation of the equipment. (ATTENTION)
INSTRUCTIONS FOR SAFE USE
No installation of this equipment should take place unless this document has been studied and understood. Handling,
transportation and installation of this equipment should only undertaken by trained personnel with proper use of lifting
equipment. See later diagrams for lifting advice. Refer to the pump nameplate for pump speed, pressure and
temperature limitations. The limits stated must not be exceeded without written permission from Armstrong.
TEMPERATURE
Where under normal operating conditions the limit of 68°C/155°F (Restricted Zone) for normal touch, or 80°C/176°F
(Unrestricted Zone) for unintentional touch, may be experienced, steps should be taken to minimize contact or warn
operators/users that normal operating conditions will be exceeded. In certain cases where the temperature of the
pumped liquid exceeds the above stated temperature levels, pump casing temperatures may exceed 100°C/212°F
and not withstanding pump insulation techniques appropriate measures must be taken to minimize risk for operating
personnel.
NOISE LEVELS
For Pumping Unit Sound Pressure Levels, see Motor Technical Data sheet (File No. 48.11L).
Select Armstrong Installation & Operation (I&O) Guides are now posted in our Wiki site.
Visit the Armstrong Wiki site at
your ideas on best practices for the installation and operation of Armstrong products.
INSTALLATION AND OPERATING INSTRUCTIONS
COMMERCIAL PUMPS
Series 4039 Belt Driven Pumps
http://www.armstrongpumps.com/wiki.html
Page 1 of 8
FILE NO.:
40.86L
DATE:
July 29, 2010
SUPERSEDES: 40.86L
DATE:
Dec. 10, 2009
and share