Dirty Hand Tools 101571 Manual de operação - Página 19

Procurar online ou descarregar pdf Manual de operação para Leme Dirty Hand Tools 101571. Dirty Hand Tools 101571 20 páginas. 15” front tine tiller

Imprimir página

Troubleshooting

PROBLEM

Engine will not start

Engine runs rough, oods during operation

Engine is hard to start

Engine misses or lacks power

Engine will not stop when throttle control

is positioned at stop

Tiller moves forward during starting

Tiller is di cult to control when tilling

(machine jumps or lurches forward)

Tines do not rotate with Driver Safety Control Lever

depressed

Tines continue to rotate after the Driver Safety

Control Lever is released

Excessive heat build up in tine area

during tilling

SOLUTION

• Add gas to gas tank.

• Connect spark plug wire to spark plug

•

rottle must be positioned at choke for a cold start

• Clean or replace air cleaner

• Drain old fuel and replace with fresh. Use gas

stabilizer at end of season

• Make sure spark plug wire is securely attached to

spark plug

• Drive safety control levers must be released to neutral

position to start the engine

• Throttle is not in proper start position

• Raise the tines for shallow tilling by lowering the

depth regulator lever

• Remove and clean fuel tank

• Clean or replace air cleaner

• Improper carburetor adjustment, take to authorized

engine service center

• Replace spark plug and adjust gap

• Drain and refill gas tank and carburetor

• See engine manual to check and adjust the

throttle linkage

• Drive lever must be released to start the engine

• Push downward on the handlebars raising the tines

• Keep the tines raised slightly for shallower tilling on

hard soils, then do a second pass going deeper

• Raise the tiller depth regulator

• Drive cable is damaged or incorrectly adjusted

• Drive belt is damaged

• Drive cable is damaged or incorrectly adjusted

• Clean the tine axle shaft

• Check transmission fluid and fill if low