Blackwood BUDDY 48 Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Fumadores Blackwood BUDDY 48. Blackwood BUDDY 48 10 páginas.

PRODUCT LOADING INSTRUCTIONS

Depending on your smoker model, the Bubby 24 is equipped with six (6) product racks

and the Buddy 48 is equipped with twelve (12) product racks for the loading of product.

Remove the wire product rack from the smoker.

Place the product directly on the product rack, leaving an air gap between each piece

of product.

With the product placed on the product rack, carefully slide the loaded product rack

into the smoker starting from the bottom rack slide position.

Repeat steps 2 and 3 until all product is loaded into the smoker. Product height will

determine how many rack slide spaces you need to maintain an air gap between each

loaded product rack.

PRODUCT UNLOADING INSTRUCTIONS

1. Before unloading the product, the control should be in the OFF position.

2. Carefully open the product loading door just enough to release the smoke from the

cabinet, then wait approximately 5 seconds before fully opening the product loading

door.

3. Product should be removed from top rack to the bottom rack

ASH REMOVAL INSTRUCTIONS

1. After each cook cycle, remove the remaining wood, ash and hot coals from woodchip

boxes. Use heat resistant gloves while handling woodchip boxes, ash container, and ash

removal tools.

2. Place small lots of them in a non combustible corrosion resistant pan and spray with

water. A non combustible corrosion resistant pan should be kept just outside the

smoker for this purpose.

3. Once wood and ash have been sprayed, place them in a heavy metal container with

a tight fitting metal lid (16 gauge minimum, capacity not to exceed 20 gallon). This

container shall be assigned for this one purpose, shall be able to be handled easily by

any employee assigned the task, and shall pass easily through any passageway to the

outside of the building. The container shall always be covered when it is being moved

through the premises. When any hole occurs in a container from corrosion or damage,

the container shall be repaired or replaced immediately.

The ashes should be carried to a separate heavy metal container (or bin), outside the

premises, that is used exclusively for the purpose of hot ash storage.