Cub Cadet 1X 221 LHP Manual do operador - Página 14

Procurar online ou descarregar pdf Manual do operador para Soprador de neve Cub Cadet 1X 221 LHP. Cub Cadet 1X 221 LHP 20 páginas. Single stage

Imprimir página
Cub Cadet 1X 221 LHP Manual do operador
Replacing Auger Paddles
The snow thrower auger's rubber paddles are subject to wear
and should be replaced if any signs of excessive wear are present.
CAUTION:
paddles to wear to the point where portions of the
metal auger itself can come in contact with the
pavement. Doing so can result in serious damage to
your snow thrower.
To change the rubber paddles, proceed as follows:
1.
Run the snow thrower until the fuel tank is empty.
2.
Pull the recoil starter handle until resistance is felt. Then tip
the snow thrower back until it rests on the handles.
3.
Remove the existing rubber paddles by unthreading the hex
washer screws which secure them to the auger. See Fig. 7-4.
Hex Washer Screw
Auger Paddle
Hex Washer Screw
NOTE: The auger paddles should be replaced one-at-a-time
so that the auger still attached can be used as an example for
positioning and re-installing the new auger.
4.
Secure the replacement rubber paddles to the auger using
the hardware removed earlier.
14
s
7— s
ectiOn
ervice
Do NOT allow the auger's rubber
Figure 7-4
Replacing Shave Plate
The shave plate is attached to the bottom of the auger housing
and is subject to wear. It should be checked periodically. There
are two wearing edges and the shave plate can be reversed.
1.
Run the snow thrower until the fuel tank is empty.
2.
Pull the recoil starter handle until resistance is felt. Then tip
the snow thrower back until it rests on the handles.
3.
Remove the four carriage bolts and flange lock nuts which
attach it to the snow thrower housing. See Fig. 7-5.
Carriage Screw
Flange Lock Nut
Reversible Shave Plate
Figure 7-5
4.
Install the new shave plate, making sure the heads of the
carriage bolts are on the inside of the housing.
5.
Adjust the shave plate as instructed in the Maintenance &
Adjustments section.
6.
Tighten securely once adjusted.
Engine
Refer to the Engine Operators manual packed separately with
your snow thrower for service information for your engine.
Side View