Cub Cadet 221 LHP Manual do operador - Página 11
Procurar online ou descarregar pdf Manual do operador para Soprador de neve Cub Cadet 221 LHP. Cub Cadet 221 LHP 20 páginas. Single stage snow thrower
Também para Cub Cadet 221 LHP: Brochura e especificações (2 páginas), Manual do operador (20 páginas), Especificações (2 páginas), Manual do operador (20 páginas)
Imprimir página
- 1. Table of Contents
- 2. Safe Operation Practices
- 2. Clearing Clogged Discharge Chute
- 2. Maintenance & Storage
- 2. Safety Symbols
- 3. Assembly & Set-Up
- 4. Controls & Features
- 5. Operation
- 6. Maintenance & Adjustment
- 7. Customer Support
- 8. Dealer
- 9. Service
- 10. Troubleshooting
- 11. Replacement Parts
- 12. Warranty
Operation
NOTE: Refer to the Engine Operator's Manual for instruction on
starting, stopping and operating the engine.
Engaging the Auger
1.
To engage the auger and start throwing snow, squeeze the
auger control against the handle. Release to stop the auger.
See Fig. 5-1.
Auger
Control
Handle
Figure 5-1
Engaging the Drive
Lift up slightly on the handle to allow the rubber paddles on the
auger to contact the pavement and propel the snow thrower
forward. Pushing downward on the handle will raise the auger
off the ground and stop the forward motion.
NOTE: Excessive upward pressure on the handle will result
in premature wear on the rubber auger blades which will
not be covered by the warranty.
Clearing a Clogged Discharge Chute
WARNING!
Never use your hands to clear a
clogged chute assembly. Shut off engine and remain
behind handles until all moving parts have stopped
before using the clean-out tool to clear the chute
assembly.
Hand contact with the rotating impeller inside the discharge
chute is the most common cause of injury associated with snow
throwers. Never use your hand to clean out the discharge chute.
To clear the chute:
1.
SHUT THE ENGINE OFF!
2.
Wait 10 seconds to be sure the impeller blades have
stopped rotating.
3.
Always use a clean-out tool or stick, not your hands.
Chute Controls
Refer to Fig. 5-2 for chute controls.
Figure 5-2
To increase the angle/distance snow is thrown, pull up/back on
the chute tilt control. To decrease the angle/distance snow is
thrown, push down/forward on the chute tilt control.
To rotate the chute to the left, pull the trigger and turn the chute
rotation control to the left. To rotate the chute to the right, pull
the trigger and turn the chute rotation control to the right.
5
Chute Tilt Control
Chute Rotation
Control
11