Cub Cadet 19A40002100 Manual do operador - Página 9
Procurar online ou descarregar pdf Manual do operador para Acessórios para cortadores de relva Cub Cadet 19A40002100. Cub Cadet 19A40002100 20 páginas. Triple rear bagger
Imprimir página
Figure 4-4
Mount Assembly on Tractor
Install mounting assembly on tractor as follows:
1.
Place the hooked ends of the mounting assembly over
the shoulder bolts, as in Fig. 4-5, on the tractor and line up
the hitch support bracket center hole with the hole on the
tractor's hitch.
Figure 4-5
2.
Install the clevis pin from hardware pack 689-00087 into the
tractor's hitch and secure with a hairpin clip inserted into the
top hole, which is the hole located closest to the head of the
clevis pin. See Fig. 4-6.
Note: The clevis pin can be fed down through the hitch
plate and secured underneath with the hairpin clip, or it
may be easier to feed the clevis pin up through the hitch
plate hole and secure with the hairpin clip on the topside.
The latter method may be preferred since it can be easier
to insert the hairpin clip. Either way will work, the decision
should be based on operator preference.
Figure 4-6
Note: If you decided to leave the hitch support only
finger tight during the assembly process, tighten all of the
hardware securely at this time.
3.
Install the bagger hanger assembly onto the mounting
assembly on the tractor by hooking it over the hitch plate
in the center, lining up the center mounting hole as seen in
Fig. 4-7.
Figure 4-7
4.
Secure the hanger assembly to the mounting assembly
using a 5/16" bolt and flange nut provided. See Fig. 4-7.
s
ectiOn
Align hole on bracket
with hole on tractor
Mounting Hole
4 — a
& i
sseMbly
nstallatiOn
9