Blagdon minipond 900 Manual do utilizador - Página 9
Procurar online ou descarregar pdf Manual do utilizador para Bomba de água Blagdon minipond 900. Blagdon minipond 900 16 páginas. Pond pump for fountains
Imprimir página
Locating your Minipond
The Minipond pump should be located on a firm and level base in the pond/water feature
in a depth of at least 10cm, but no more than
It is advisable to keep the pump off the bottom of the pond to avoid silt entering the pump
causing excessive wear and increasing pre-filter cleaning.
Fountain
Make sure there is ample cable from mains supply. Place pump in desired location. Add
Fountain extension pipes so fountain head is above surface of the pond. Fountain height
can now be adjusted, see 'Adjusting fountain display' diagram below. See "Getting to
know your Minipond" for parts and descriptions.
ADJUSTING THE FOUNTAIN DISPLAY
1. Adjust height by push fitting 5cm long
extension pipes onto ball joint until desired
height has been achieved.
2. Adjust flow by turning clockwise to
increase flow, anti-clockwise to
reduce flow.
3. Adjust ball joint to enable the extensions to
be moved compensating for an uneven
pond floor.
Tip:
Ensure that any fountain or feature fitted does not empty water out of pond/water feature.
Water Feature
Install as Fountain but remove pre-filter foam (if fitted) from cage. Depending on water
feature to be supplied, your Minipond can be used with the flow control and the ½" hose
fitting or ¾" hose fitting (not supplied with 700 model) which can be screwed directly
into pump body. Hose clips should be used to secure hose. Foam free cage will lower
the need for monthly maintenance and not hinder its performance for when running
a water feature.
Tip:
The larger ¾" hose will give maximum performance when fitted to the
Minipond 900/1600.
INSTALLATION
_
1.25m (700) 2m (900/1600).
∆
3
1
2
BELL FOUNTAIN
Adjust bell by
moving head
higher for
small bell
and lower
for a wider
bell shape.
6
7