DISCOVER LYNK Edge Card Victron Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Acessórios para câmaras DISCOVER LYNK Edge Card Victron. DISCOVER LYNK Edge Card Victron 9 páginas. Lithium ion battery

Imprimir página

6. System Set Up

6.1

Synchronizing the Victron System with the AES Battery

Once the VE.Can and CAN-bus bit rate is set, communication of the AES battery parameters will be automatic.

During normal operation, the charge parameter limits are set by the BMS of the AES battery and communicated through the system

by the CCGX to the inverter/charger and MPPT.

To optimize performance of a Victron system the following items need to be manually set using the CCGX.

Navigate from the Device List screen > Settings > System Setup.

From the System Setup menu scroll down to select each item and then set as indicated.

•

Battery Monitor: DISCOVER on CAN-bus

•

DVCC - Distributed Voltage and Current Control: ON

•

SVS - Shared voltage sense: OFF

•

STS - Shared temperature sense: OFF

•

Limit charge current: ON

•

Max charge current: Installed number of AES batteries x (42-48-6650: 92A < 130A) or (44-24-2800: 78 A < 110 A)

(7) SVS should be set to OFF (there have been instances of conflict reported by Victron Support when SVS is set to ON and used with a Lithium BMS).

(8) Limit charge current works across the whole system. MPPTs are automatically prioritized over the mains. In case the AES BMS requests a maximum charge

current that is different from the user-configurable setting, the lower of the two will be used.

(7)

•

To avoid conflicting network information and data, do not

use a Victron BMV battery monitor when using AES LYNK

Communication Gateway.

▲ NOTE

(8)

discoverbattery.com